What should I do if the glass appears to be frying in the process of heating?

The so-called fryer refers to the bursting of the glass during the heating process, accompanied by a squeaking sound. This is because the glass is in the process of eliminating the original stress, the stress imbalance caused by the failure of the fryer, if it is not handled properly, will have serious consequences. Therefore, it is necessary to take corresponding measures according to the specific situation and reduce the losses to a lower limit.

1. For the thick plate (especially greater than 12mm), it is more common to have a fryer in tens of seconds. If this happens, stop the main drive immediately and turn off the heating; if the large piece is cracked Shake the glass out as soon as possible by hand; if it is a pulverizing fryer, this situation can be shaken left and right, so that the glass fragments are scattered on the lower radiant panel; if the glass layout is larger than 1/2 furnace, the furnace should be cooled down. Cleaning (including roller table) If the glass layout is smaller than 1/2 furnace, the production can be continued without cooling. Before the production, it is better to use the frosted glass to face the frosting down, and take more time in the furnace (heating off) to leave the roller on the roller. The glass is stained away. Then use a piece of the product glass to sprinkle some sulfur powder (2-3 two) on the furnace, and then normal production.

2. For thinner glass, the fryer is mostly broken into large pieces. The heating and main drive should be turned off immediately, and the glass should be shaken out.

3, no matter the thickness of the glass, it is more dangerous to get stuck between the two roller paths after the fryer. Once this happens, there are three ways to do this:

a, thorough cooling treatment;

b. Raise the furnace to a certain height, carefully pick or push the glass with a long rod, and then heat up the furnace to continue production;

c. Heat on and gently shake the roller path from side to side, while shaking to observe the glass condition until the glass falls below.

Topline is China leading manufacturers and suppliers of Paper Yarn,Natural Paper Yarn, and we are specialize in Paper Yarn Cones, Novelty Paper Yarn, etc.

As a natural eco-friendly and healthy knitting material, paper yarn can be applied in various fields. Paper yarn knitwear or accessory satisfy people`s need of fashion, comfort and environmental protection and bring us new feel, therefore it has good development prospect.

Paper material is made by the method of traditional paper production. It is new type material made from wood fibre. Paper material is produced in Japan and the Netherlands. It is light with the feel of linen and has excellent moisture absorption and sweat releasing property.

we have below paper yarn for your choice:

MONET; Nm6 50%paper 32% cotton 16%polyamide 2% sequins yarn

CARTA: Nm23 76% paper 24% polyamide yarn

Paper Yarn

Paper Yarn,Natural Paper Yarn,Paper Yarn Cones,Novelty Paper Yarn

Consinee Group Go., Ltd. , https://www.consineeyarn.com